Welcher umschaltbare Joystick für Quadro Jumbo
Servus aus Wien!
Nach einem langen Tagesausflug an die Weinstraße steht nun ein Quadro Jumbo bei mir. Und diesmal kommen sogar echte Platinen rein, (vorerst) kein Pi2Jamma - ich bin auf den Geschmack gekommen.
Insbesondere am linken Joystick funktioniert die 4-8-Wege-Umschaltung nicht mehr, die Mechanik scheint verklemmt zu sein. Direkt am Joystick bereits (die gewagte Konstruktion zur Bedienung von außen ist ein anderes Thema, aber wenn die grundsätzliche Umschaltung flüssig funktionierte, wäre das vielleicht eh auch kein Problem).
Neue Joysticks - wenn schon, denn schon, denke ich.
Welche sind für den Quadro, insbesondere die von außen bedienbare Umschaltung, geeignet?
Grüße
hp
Liste der Anhänge anzeigen (Anzahl: 2)
Hallo hp,
der gezeigt Mag-Stick müsste der sein, den ich auch an meinem Quadro verbaut habe, sieht zumindest so aus und die Maße stimmen auch. Im übrigen geht nix über 4 / 8 Wege Umstellung, jawohl!
Gruß, André
Anhang 16929Anhang 16930
Liste der Anhänge anzeigen (Anzahl: 2)
Damit alle wissen, worum es eigentlich geht:
Anhang 16931 Anhang 16933
Liste der Anhänge anzeigen (Anzahl: 1)
Mittwoch kurz vor Mitternacht in London bestellt, Freitag zu Mittag bereits von DHL geliefert. Ich bin baff.
Ultimarc Mag-Stick Plus, der mit 4-8-Wege-Umschaltung von oben über den Steuerknüppel. Spielt ausgezeichnet.
https://www.ultimarc.com/arcade-cont...mag-stik-plus/
Wenn sie schon vorhanden ist, möchte ich dennoch die Umschaltung von außen ermöglichen, auch weil die aktuelle Stellung des Joysticks nicht erkennbar ist. Meine Idee: Auf den Gewindestift wird eine Gabel bzw ein u-förmiges Etwas aufgeschraubt, welche den Umschalter am Joystick jeweils von links bzw. rechts anschiebt. Der Vorteil daran ist auch, dass keine fixe Verbindung mehr besteht, welche bisher nur durch die sehr wackelige Konstruktion funktioniert hat (das Ende des Quadro-Hebels beschreibt ja einen Kreisbogen, der noch dazu gegenläufig zum Joystickschalter ist).
Ich bin kein Metallbauer oder Schweißer, der so etwas herstellen könnte - ich bin noch auf Ideensuche. Möglicherweise etwas 3D-Gedrucktes?
Anhang 16934
Liste der Anhänge anzeigen (Anzahl: 1)
Im Original sieht das übrigens so aus. Du machst Dir da IMHO zu viele Gedanken...
Anhang 16943