4. Button an TV Ideal Standard
Hi
Hab jetzt schon viele Beiträge gelesen und auch die Suchfunktion schon mehrfach genutzt, aber bis jetzt noch nichts dazu gefunden.
Hat jemand ne ausführliche Anleitung wie ich nen 4. Button in meinen TV Ideal Standard bauen kann?
weiß jemand wo ich ein neues Kontrollpanel (ohne Löcher herbekomm) ?
Danke
Liste der Anhänge anzeigen (Anzahl: 1)
Button 4 und Paneel
Hallo miteinander ...
Erstmal zum Paneel...
Button besorgen und einarbeiten, siehe Foto im Anhang.
So,
wenn du ein Spiel besitzt, das den vierten Button benötigt, musst du auch die entsprechende Pinout besitzen,
ich kenne jedenjalls kein Jammaspiel mit 4 Buttons ...
jedenfalls wenn du ein Jamma-Pinout mit der Kennzeichnung des 4ten Buttons besitzt kannst du jetzt an deinem vierten Button 2 Kabel anlöten und diese mit deinem Jamma-Adapter verbinden,
eins an Masse und das andere an dem Ausgang des 4ten Buttons am Jamma Adapter....
Logisch, oder ....
Jedenfalls kann ich es nicht viel besser erklären
Gruß Willi ....
Zusätzlich zu ADP-Adaptern
Folgende Pinout kann ich noch mitteilen:
Der ADP-Adapter hat noch folgende Pinout oder besser gesagt Belegung:
ZS1 = 2ter Spieler Links
ZS2 = 2ter Spieler Unten
ZS3 = 2ter Spieler Rechts
ZS4 = 2ter Spieler Oben´
ZS5 = 2ter Spieler A I
ZS6 = 2ter Spieler A II
ZS7 = 2ter Spieler A III
ZS8 = 1ter Spieler A III
Liste der Anhänge anzeigen (Anzahl: 2)
Bauanleitung vom mir selbst erstellt ....
Siehe da ...
so sollte es klappen,
wenn das keiner versteht,
bitte ich Wally es in kürze zu löschen ...
Fehler sind nicht auszuschließen, also keine Garantie meinerseits ...
Gruß ....
Liste der Anhänge anzeigen (Anzahl: 1)
Bild 3 im Anhang ...
Nun kommt Bild 3 ....
Achtung, Masse kann auf dem ADP-ADapter angelötet werden ...
´Saufen ist nicht das Problem ...
Hauptsache man sollte nach 2 Jahren Konsum
seinen eigenen Kasten wieder erkennen,
Gruß Willi ...
Liste der Anhänge anzeigen (Anzahl: 1)
Naja es is ja keine jamma platine die die vier buttons benötigt sondern das hoffentlich bald angeschlossene MVS Board.
Also jamma pinout hab ich hier,
hab gedacht an 25 und an c den 4. button anschließen :confused:
Dann kauf dir doch mal so ein Bord
Hallo,
da kann ich dir auch nicht helfen, mein Bord habe ich verkauft und die Pinout habe ich nun logischerweise auch nicht mehr...
Wenn mann einen TV-Ideal Automaten mit einem 4ten Button ausrüsten will, dann muss mann das auch vernüftig machen und nicht einfach an den letzten Adapter anlöten, also bei dir ist es dann der Jamma Adapter...
Hab nun kein Bock mehr und "Ich habe fertig ...."